（重切削）U型系列可调多轴器可调多轴器重庆丰正机械有限公司

咨询热线： 13896006908

产品展示

加工案例

重庆丰正机械有限公司

联系人：朱经理

手机：13896006908

电话：023-67188505

传真：023-67188506

地址：重庆市渝北区回兴工业园区兰馨大道2号

可调多轴器

（重切削）U型系列可调多轴器

(Heavy cutting)Type U multi-spindle tool

◎本体结构利用齿轮箱配合万向节头所组成，容易调整加工孔距不受齿轮所限制，节省调整的时间，也少有死角的限制。其齿轮、轴承、输出轴、万向节均采用强力系列，适合加工钢件等强力场合。为保万向节头之寿命，移动范围不得超过15度，等于垂直之前後左右30mm以内。

(尽量配合工作之孔距坐标，设计齿轮箱结构即定镗孔位)

◎The basic frame consists of gear case and cardan joint.The hole-distance is easy to control and will not be affected by the gears.The set up time is thus saved and it is mostly free of dead angles.It is very suitable for working of round holes.The gear.bearing.output shaft and cardan joint are all intensified，so it is good at machining hard parts such as steel parts.To ensure the lifetime of the cardan joint，the moving range should be confined within 15 degrees，which means within a distance of 30mm to the vertical status.

(We will design the structure of gear case，that is，the position of the boring hole as much as possible according to the coordinate of per hole.)

咨询热线：

13896006908

在线咨询

规格参数

※万向节注意事项：

1.调整时不能超过规定的角度15度

2.如超过此极限心轴易磨损或断裂

3.工作时应经常加润滑油脂

※Note of cardan Joint

1.Do not set the angle to more than the specifled l5 degrees.

2.If the limit is exceeded，the shaft will be easy to wear or break.

3.During work，lubrication should be added frequently.

型号 Type	SWU165	SWU200	SWU250	SWU100×165	SWU120×200	SWU120×300
筒夹规格Collet/ 最大钻孔能力 Max.Drilling Capacity	ER20/13 ER25/16	ER20/13 ER25/16	ER20/13 ER25/16	ER20/13 ER25/16	ER20/13 ER25/16	ER20/13 ER25/16
转速比 Gear Ratio	1∶1	1∶1	1∶1	1∶1	1∶1	1∶1
最小距离（二轴间） Lowest Distance(Two Spindle)	42	42	42	42	42	42
最大轴心范围 Max.Range of Centers	165	200	250	100×165	120×200	120×300
轴数 Spindle	2-10	4-12	4-12	3-8	4-12	6-14